Bushings Installation - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
3. Remove oil seal and large bushing from gimbal housing using a two-jaw puller and slide
4. Remove small bushing from gimbal housing using a bushing removal tool.
INSTALL BUSHINGS
1. Install gimbal ring hinge pin bushings as follows:
90-863160 MAY 2000
hammer assembly.
a - Two Jaw Puller
b - Slide Hammer Assembly
a - Bushing Removal Tool (Snap-On Tool Company P/N CG40CB)
a. Install hinge pin into bearing and seal driver.
a
a - Hinge Pin
b - Seal Driver (P/N 91-43578A1)
SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY
a
22438
a
b
22452
a
b
Page 4B-21
22454
22452