Mercury BRAVO Service Manual page 95

SERVICE MANUAL NUMBER 28
13. Place a large I.D. flat washer and bushing on each end of the anchor pin. Be sure to
14. Loosen the nuts which secure the trim cylinders to the forward anchor pins. Move the
15. Place the bushings (with the smaller diameter end facing inward) and the small I.D. flat
16. Tighten the forward and aft anchor pin locknuts until the locknuts and washers contact
17. Attach the trim cylinder caps hand tight. If the caps will not catch the threads, recheck
90-863160 MAY 2000
install the bushings with the small diameter end facing outward.
a
c
a - Anchor Pin
b - Large I.D. Washers
c - Bushings
cylinder pivot ends outward and place them over the aft anchor pin.
washers onto each end of the anchor pin. Install locknuts.
against anchor pin shoulder.
the tightness of the anchor pin nuts.
a - Trim Cylinder Pivot Ends
b - Bushing
c - Small I.D. Flat Washer
d - Locknut
e - Trim Cylinder Cap
REMOVAL, INSTALLATION AND ADJUSTMENTS
b
c
c
a
d
b
22029
e
22029
Page 2A-27