Mercury BRAVO Service Manual page 86

REMOVAL, INSTALLATION AND ADJUSTMENTS
12. Connect the power steering assembly to the transom.
13. Connect the power steering clevis to the steering lever.
14. Lubricate the steering cable end with a liberal amount of Special Lubricant 101 and
15. Start the coupler nut on the tube. Do not tighten at this time.
Page 2A-18
a. Lubricate bushings with Special Lubricant 101.
a - Bushings
b. Slide the power steering cylinder bushings between the transom mounting brackets.
Tighten the two pivot bolts by hand. At the same time, move the steering assembly
slightly to ensure proper pin engagement into the pivot bushings.
c. Ensure that the washer tangs straddle the ridges on the inner transom plate.
a - Pivot Bolt
b - Washer Tang
d. Torque the pivot bolts to 25 lb-ft (34 Nm). Bend the washer tabs against the
corresponding flats on both pivot bolt heads.
e. Make sure the power steering control valve pivots freely.
a. Lubricate the clevis pins with Special Lubricant 101.
b. Install the clevis pin in the clevis from the top.
c. Secure the pin in the clevis with a cotter pin. Spread the cotter pin ends.
install the cable through the guide.
a
a
b
a
SERVICE MANUAL NUMBER 28
b
90-863160 MAY 2000
71901
22033