SERVICE MANUAL NUMBER 28
Outer Propeller Shaft Servicing
1. To remove roller bearing and oil seal from outer propeller shaft using slide hammer puller
2. Install roller bearing using bearing installation tool.
3. Coat outer diameter of oil seal with Loctite 271. Press oil seal into outer propeller shaft
90-863160 MAY 2000
with three-jaw puller.
a -
Slide Hammer Puller (P/N 91-34569A1)
b -
Outer Propeller Shaft
a -
Bearing Installation Tool (P/N 91-805352T)
b -
Outer Propeller Shaft
using seal installation tool until tool bottoms out against shaft. Lubricate lips of oil seal
and fill area between lips of seal with Quicksilver Special Lubricant 101.
a -
Seal Installation Tool (P/N 91-805358T)
b -
Outer Propeller Shaft
BRAVO THREE GEAR HOUSING
a
b
a
b
a
b
72216
72217
72235
Page 3D-23