Mercury BRAVO Service Manual page 394

SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY
3. Install shift cable wrapping approximately 2 in. from gimbal housing.
Water leakage may result if clamp is not installed properly. Check that bellows end
is not flattened out when crimping in the followIng step.
4. Install and compress shift cable bellows crimp clamp, maintaining a 1/2 in. diameter
Page 4B-52
a
a - Shift Cable Wrapping
round outer diameter Ensure that clamp is crimped evenly to maintain a good seal
between bellows and shift cable. Do NOT allow bellows to flatten.(Plans for Crimp
Clamp Tool are on p. 4B-57)
a - Crimp Clamp
CAUTION
a
SERVICE MANUAL NUMBER 28
76639
22117
90-863160 MAY 2000