Speedometer Water Passage (Bravo Three); Inspection And Cleaning (Bravo Three) - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
2. Coat outer diameter of oil seal with Loctite 271 and press oil seal into bearing carrier
Speedometer Water Passage
Inspection and Cleaning
1. Inspect opening (pitot tube), on leading edge of gear housing, for obstruction. Clean
2. Inspect water passage seal for nicks, cuts or distortion. Replace if necessary.
90-863160 MAY 2000
using seal installation tool until tool bottoms out against housing. Lubricate lips of oil seal
and fill area between lips of seal with Quicksilver Special Lubricant 101.
a - Seal Installation Tool (P/N 91-805372)
b - Bearing Carrier
opening with a short piece of wire, if necessary. If obstruction cannot be removed with
wire, carefully reopen tube using a 5/64 in. (2 mm) diameter drill bit. Do not drill beyond
a depth of 2-7/16 in. (62 mm).
a - Opening (Pitot Tube)
a - Water Passage Seal
BRAVO THREE GEAR HOUSING
a
b
a
a
75897
72448
72449
Page 3D-27