BRAVO ONE GEAR HOUSING
Driven Gear Bearing Cup Removal and Inspection
1. Remove bearing cup and shims using slide hammer puller. Replace tapered roller
Driven Gear Bearing Cup Installation
1. Install driven gear bearing cup with original thickness shim(s) using bearing driver.
NOTE: If a MC-l propeller shaft is not available, use Driver Rod 91-37323 (from Bearing Re-
moval and Installation Kit, 91-31229A7).
Page 3B-28
bearing and cup if cup is pitted, grooved, scored, worn uneven, discolored from
overheating or has metal particles embedded in the cup.
c
a -
Slide Hammer Puller
b -
Bearing Cup
c -
Shims
Ensure that cup is not canted. Coat cup outside diameter with gear lube.
a -
Shim(s)
b -
Bearing Cup
c -
Driver (91-31106)
d -
Old Propeller Shaft Or Driver Rod
a
b
d
c
b
a
SERVICE MANUAL NUMBER 28
19808
75922
90-863160 MAY 2000