Mercury BRAVO Service Manual page 421

SERVICE MANUAL NUMBER 28
3. Connect the ohmmeter leads to the large terminals on the solenoid.
4. Zero Ohms Reading (Full Continuity)-Solenoid is OK.
IN/DOWN SOLENOID
1. Connect a 12 volt positive (+) supply lead to the green-white harness wire terminal.
2. Connect the negative (–) supply lead to the solenoid ground terminal.
3. Connect the ohmmeter leads to the large terminals on the solenoid.
90-863160 MAY 2000
a - OUT/UP Solenoid
b - 12 volt Positive (+) Supply Lead
c - Negative (–) Supply Lead
d - Ohmmeter Leads
e - BLUE/WHITE Harness Wire Terminal
f - Solenoid Ground Terminal
High Ohms Reading (No Continuity)-Replace solenoid.
a - IN/DOWN Solenoid
b - 12 Volt Positive (+) Supply Lead
c - Negative (–) Supply Lead
d - Ohmmeter Leads
e - GREEN/WHITE Harness Wire Terminal
f - Solenoid Ground Terminal
f
c
e
a
c
f
b
e
OILDYNE TRIM PUMP
b
d
d
a
22493
22494
Page 5A-21