Transom Assembly Installation - Mercury BRAVO Service Manual

REMOVAL, INSTALLATION AND ADJUSTMENTS

Transom Assembly Installation

Avoid continuity wire failure. Position the steering lever ground wire as shown or
the wire may fatigue and break.
1. Install the transom assembly. Tighten locknuts evenly, starting from the center and
Page 2A-12
a - Steering Lever
b - Transom Plate
c - Continuity Wire
working outward. Torque to 23 lb-ft (31 Nm).
a
a - Locknuts and Flat Washers
b - Power Trim Hoses
c - MerCathode Wires
d - Continuity Wire
e - Trim Limit And Trim Position Sender Wires
f - Grounding Bolt
g - Speedometer Connection
h - Shift Cable
CAUTION
a
a
h
SERVICE MANUAL NUMBER 28
b
c
g
e
f
d
a
b
c
90-863160 MAY 2000
22028
73902