SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY
Gimbal Ring Servicing
GIMBAL RING IDENTIFICATION
The gimbal ring used on various model transom assemblies can be identified as shown in
the following illustration:
REMOVING BUSHINGS
Be careful not to damage bores when removing self-lubricating bushings in the fol-
lowing steps.
1. Tap out and remove gimbal ring lower swivel pin bushing using a suitable mandrel.
2. Remove gimbal ring hinge pin bushings (port and starboard) using a suitable mandrel.
Page 4B-20
a
a -
Standard Gimbal Ring Identification (Two Ribs)
b -
Magnum and High Performance Gimbal Ring Identification (Filled Area)
a -
Suitable Mandrel
a -
Suitable Mandrel
b
CAUTION
a
a
SERVICE MANUAL NUMBER 28
75272
22451
22452
90-863160 MAY 2000