Connect Electrical Leads To Controller Assembly - Mercury BRAVO Service Manual

CORROSION PROTECTION - ALL MODELS
DO NOT paint sacrificial anodes or MerCathode System electrode assembly, as this
will render them ineffective as galvanic corrosion inhibitors.
8. Position and secure electrode assembly to gimbal housing using two 1-3/8 in. (35 mm)

Connect Electrical Leads to Controller Assembly

NOTE: If black (ground) wire is not available at terminal block or from wire harness, install
a separate lead between controller negative (–) terminal and negative (–) battery cable at-
taching point on engine.
1. Securely connect electrical leads to controller assembly. (See Wiring Diagrams,
2. Apply a thin coat of Quicksilver Liquid Neoprene (92-25711) to ALL electrical
Page 7A-12
long screws, flat washers and lockwashers. Torque to 25 lb-in. (2.8 Nm). Do NOT
overtighten.
e
a - Electrode Assembly
b - Screw (2)
c - Flat Washer (2)
d - Lock Washer (2)
e - Hydraulic Connector Block
following.)
connections.
CAUTION
a
c
d b
SERVICE MANUAL NUMBER 28
70771
90-863160 MAY 2000