Mercury BRAVO Service Manual page 216

BRAVO ONE GEAR HOUSING
31. Install gear housing to drive shaft housing. Torque fasteners to 35 lb-ft (47 Nm).
32. Install anodic plate. Torque bolt to 20 lb-ft (27 Nm).
33. Install rubber plug.
34. Reinstall sterndrive unit. Refer to SECTION 2A - Removal, Installation and Adjustments.
35. Fill sterndrive unit with Gear Lube. Refer to SECTION 1B - Maintenance.
Page 3B-44
a
a - Nuts And Washers (3 Each Side)
b - Bolt (Located In Anodic Plate Cavity)
a
b
a - Bolt
b - Anodic Plate
a - Rubber Plug
SERVICE MANUAL NUMBER 28
b
a
90-863160 MAY 2000
76879
76880
22093