SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
4. Apply Loctite 271 to bell housing threads and install hinge pins. Torque hinge pins to
5. Install trim position sender as follows:
Page 4A-14
150 lb-ft (203 Nm).
a -
Bell Housing
b -
Gimbal Ring
c -
Hinge Pin Tool (P/N 91-78310)
a. Place sterndrive unit in the full DOWN/IN position.
b. Turn center rotor of trim limit switch to align index mark with index mark on sender
body.
a -
Index Marks
c. Install trim position sender and secure with attaching hardware.
a -
Attaching Hardware
a
a
a
SERVICE MANUAL NUMBER 28
c
b
90-863160 MAY 2000
76619
71218
71220