Driven Gear Bearing Cup Installation (Bravo Two); Speedometer Water Passage (Bravo Two); Pickup Inspection And Cleaning (Bravo Two) - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
Driven Gear Bearing Cup Installation
1. Install driven gear bearing cup with original thickness shim(s) using bearing driver.
NOTE: If a MC-l propeller shaft is not available, use Driver Rod 91-37323 (from Bearing Re-
moval and Installation Kit, 91-31229A7).
Speedometer Water Passage
Pickup Inspection and Cleaning
1. Inspect pitot tube on leading edge of gear housing for obstruction. Clean opening with
90-863160 MAY 2000
Ensure that cup is not canted. Coat cup outside diameter with gear lube.
a - Driver - 91-63626
b - Old MC-I Propeller Shaft
c - Bearing Cup
d - Shim(s)
a short piece of wire. If obstruction can not be removed with wire, carefully re-open tube
using a 5/64 in. (2 mm) diameter drill bit. Do not drill beyond a depth of 2-7/16 in. (62
mm).
a - Pitot Tube
BRAVO TWO GEAR HOUSING
b
a
c
d
a
19917
22462
Page 3C-27