SERVICE MANUAL NUMBER 28
Pump Shaft Oil Seal Replacement
1. Remove the pump attaching screws with a hex lobular socket or standard 3/16 in.
2. Remove pump. Do NOT loosen or remove the pump assembly screws.
3. Remove the oil seal by prying out with a screwdriver.
4. Remove and replace the O-rings on the pump base if they are worn.
5. Install a new seal with the lips toward the pump. The oil seal can be pressed in by hand.
90-863160 MAY 2000
(5 mm) socket.
a -
Screw
b -
Pump Assembly Screw
a -
Oil Seal
b
a
OILDYNE TRIM PUMP
a
Page 5A-37
70870
50371