SERVICE MANUAL NUMBER 28
7. Clean shift cable bellows mounting flange on gimbal housing with sandpaper and wipe
Read and follow package label directions before using bellows adhesive.
8. Apply bellows adhesive to shift cable bellows mounting surface. Allow to dry until
9. Install shift cable bellows on gimbal housing flange. Position hose clamp as shown.
90-863160 MAY 2000
clean with lacquer thinner.
a -
Mounting Flange
adhesive is no longer tacky (approximately 10 minutes) before installing.
a -
Bellows Mounting Surface
Torque to 35 lb-in. (4 Nm).
a -
Shift Cable Bellows
b -
Hose Clamp
SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY
a
WARNING
a
b
a
76662
22454
76663
Page 4B-31