Mercury BRAVO Service Manual page 480

TRIM CYLINDERS
6. Coat anchor pin threads with 2-4-C Marine Lubricant with Teflon to prevent threads from
7. Hand thread locknuts onto anchor pin. Install plastic caps.
All 4 anchor pin locknuts must be tightened as described following or damage to
sterndrive unit may result from drive unit moving too far inward.
8. Tighten 4 anchor pin locknuts until nuts and washers bottom out against anchor pin
9. Reconnect trim hoses after air bleeding power trim cylinders and hoses following proce-
Page 5B-22
galling.
a - Aft Anchor Pin (Shorter)
b - Washers (2) - Large I.D.
c - Bushings
d - Washers (2) - Small I.D.
e - Locknuts (2)
f - Plastic Caps (2)
shoulder.
dures outlined in Section 5A.
a
c
b
CAUTION
SERVICE MANUAL NUMBER 28
e
f
d
c
22029
90-863160 MAY 2000