Mercury BRAVO Service Manual page 526

POWER STEERING
3. Remove oil seal. Remove shim stock.
4. Install new oil seal. Properly support pump reservoir so that reservoir back does not dis-
5. Install pulley, as follows, using Pulley Pusher Assembly 91-93656A1, and a long straight
Page 6A-22
a - Seal
b - Suitable Tool
tort.
a - New Oil Seal - Metal Side Up
b - Suitable Mandrel
c - Pump Reservoir
edge:
a. Place pulley on pump shaft.
b. Thread stud ALL-THE-WAY into pump shaft. Place bearing over stud. DO NOT use
spacer from kit.
c. Thread nut onto shaft. Thread shaft (and nut) ALL-THE-WAY onto stud.
d. Using a long straight edge (to check drive belt alignment), turn large pusher nut until
drive belt is parallel to straight edge.
b
b
c
SERVICE MANUAL NUMBER 28
a
a
90-863160 MAY 2000
22152
22151