Exhaust Bellows Removal; Exhaust Bellows Cleaning And Inspection - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
13. Remove tools and install cable on shift plate assembly, being careful not to lose
Exhaust Bellows (If Equipped)
Removal
1. Remove sterndrive unit. Refer to Section 2A.
2. Loosen clamps and remove bellows.
Cleaning and Inspection
1. Inspect exhaust bellows for internal charring, cracks, cuts or hardening.
2. Clean old adhesive from bellows mounting flange on gimbal housing and on bell housing
3. Clean old adhesive from mounting surface of exhaust bellows if using old bellows.
4. Roughen exhaust bellows mating surfaces with sandpaper and wipe clean with lacquer
90-863160 MAY 2000
adjustment.
a - Barrel
b - Hole In Tool
a - Clamps
b - Bellows
with lacquer thinner.
thinner.
SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
a
b
a
a
b
Page 4A-27
22120
22116