Driven Gear Bearing Installation (Bravo Two); Driven Gear Bearing Cup Removal And Inspection (Bravo Two) - Mercury BRAVO Service Manual

BRAVO TWO GEAR HOUSING
Driven Gear Bearing Installation
1. Apply Gear Lube to inside diameter of new bearing. Place a suitable mandrel (old
Driven Gear Bearing Cup Removal and Inspection
1. Remove bearing cup and shims using slide hammer puller. Replace tapered roller
Page 3C-26
bearing race) against new bearing race. Place another mandrel on face of gear and
press gear and bearing together.
a - Hard Wood Or Metal Block
b - Driven Gear
c - Tapered Roller Bearing
d - Mandrel – Contacting Inner Race
bearing and cup if cup is pitted, grooved, scored, worn uneven, discolored from
overheating or has metal particles embedded in the cup.
c
a - Slide Hammer Puller, 91-34569A1
b - Bearing Cup
c - Shims
a
b
SERVICE MANUAL NUMBER 28
d
c
b
a
90-863160 MAY 2000
22108
19808