Exhaust Bellows Installation - Mercury BRAVO Service Manual

SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
Installation
IMPORTANT: All replacement bellows should be P/N 18654. Do not use earlier model
bellows.
Be sure to follow label directions when using bellows adhesive.
1. Apply bellows adhesive to mounting surfaces on inside of bellows. Allow adhesive to dry
Bellows clamps may corrode if grounding clips are not installed.
2. Position grounding clips on bellows.
3. Install exhaust bellows on gimbal housing. Torque clamp to 35 lb-in. (4 Nm).
Page 4A-28
until no longer tacky (approximately 10 minutes).
a
a - Apply Bellows Adhesive
b - Grounding Clips
c - Part Number -
a - Exhaust Bellows
b - Hose Clamp
WARNING
CAUTION
b
a
SERVICE MANUAL NUMBER 28
c
b
a
90-863160 MAY 2000
22079
76660