Trim Cylinder Installation - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
Installation
NOTE: Refer to "Special Information" at the front of this section before reinstalling trim cylin-
ders.
1. Install trim cylinder forward mounting hardware as shown.
2. Coat anchor pin threads with 2-4-C Marine Lubricant with Teflon (to prevent threads
3. Hand thread locknuts onto pin. Do NOT tighten at this time.
IMPORTANT: On Bravo One, Two, and Three Models, the Trim-In Limit Insert , must
be properly positioned before installing the trim cylinder anchor pin in the following
steps.
NOTE: Ensure that the Trim-In Limit Insert is reinstalled in the same position that is was in
prior to removal of the sterndrive unit. If you are not sure of it's original position, contact the
boat manufacturer for their recommendation. Refer to Special Information at the front of this
section before reinstalling the Trim-In Limit Insert.
4. Ensure that the Trim-In Limit Insert is positioned as shown for the appropriate Bravo
Bravo One and Two (Positioned Forward)
IMPORTANT: The position of the Trim-In Limit Insert on the Bravo Three sterndrive
unit should only be changed after the boat has been properly tested. Contact the boat
manufacturer if you are not sure of the original position for a particular boat applica-
tion.
5. Install trim cylinder aft mounting hardware as shown.
90-863160 MAY 2000
from galling).
a - Anchor Pin (1)
b - Slots (2)
c - Flat Washer (Large I.D.) (2)
d - Snap Rings (2)
e - Bushings (4)
f - Washers (Small I.D.) (2)
g - Locknut (2)
h - Plastic Cap (2)
model.
a
a - Trim-In Limit Insert
b c d e e
a
75157
Bravo Three (Positioned Aft)
TRIM CYLINDERS
f g
h
a
Page 5B-21
71489
75158