Mercury BRAVO Service Manual page 517

SERVICE MANUAL NUMBER 28
7. Connect the power steering unit to the steering lever.
8. Lubricate the steering cable end with a liberal amount of Special Lubricant 101 and
9. Start the coupler nut on the cable guide tube. Do not tighten at this time.
10. Connect the cable end to the clevis with the forward clevis pin. Spread the cotter pin
90-863160 MAY 2000
a. Lubricate the clevis pins with Special Lubricant 101.
b. Install the clevis pin in the clevis from the top.
c. Secure the pin in the clevis with a cotter pin. Spread the cotter pin ends.
install the cable through the guide.
ends.
Control Valve
a - Clevis
b - Rear Clevis Pin
c - Forward Clevis Pin
d - Steering Cable End
e - Cable Guide
f - Pivot Bolt
g - Coupler Nut
h - Cotter Pins
b
a
f
g
h
c
d
e
POWER STEERING
71901
Page 6A-13