Installing Gear Housing On Drive Shaft Housing - Mercury BRAVO Service Manual

BRAVO THREE GEAR HOUSING

Installing Gear Housing On Drive Shaft Housing

1. Install gear housing to drive shaft housing as follows:
2. Reinstall drive unit. Refer to Section 2A - Removal, Installation and Adjustments.
3. Fill drive unit with gear lube. Refer to Section 1B - Maintenance.
Page 3D-42
a. Lower upper drive shaft housing down onto gear housing and install 6 locknuts and
washers. Torque nuts to 35 lb-ft (47 Nm).
a - Locknuts and Washers (6)
b. Install bolt in anode cavity. Torque to 35 lb-ft (47 Nm).
a
a - Bolt
c. Install anode and torque to 20 lb-ft (27 Nm). Install rubber plug.
a - Bolt
a
a
SERVICE MANUAL NUMBER 28
76803
76804
76832
90-863160 MAY 2000