Rear Crankcase Cover Installation - Honda MUV700 big red Service Manual

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Drive a new bearing in with the sealed side facing
down.
TOOLS:
Driver
Attachment, 37 x 40 mm
Pilot, 17 mm
INSTALLATION
07749·0010000
07746· 0010200
07746· 0040400
Blow through the oil passage in the crankcase cover
wi t h compressed air.
Clean the crankcase and cover mating surfaces.
Apply engine oi l to the lips of new oil seals, and
install them into the crankcase cover until they are
fully seated.
Coat new O-r ings with engine oil and install them
into the joint coll ar grooves. Install the oil joi nt col-
lar into the crankcase.
Install the two dowel pins and a new gasket.
Make sure that the washers are installed on the out-
put shaft, reverse idle shaft and gea r shift spindle,
and that the shift drum position is neutral as shown
(switch pin groove is in positioned lengthwise).
12-7