Bearing Replacement; Alternator Cover Installation - Honda MUV700 big red Service Manual

ALTERNATOR/STARTER CLUTCH
11-8
BEARING REPLACEMENT
Remove the torque limiter bearings in the alternator
cover and rear crankcase covers, using the special
tools.
TOOLS:
Beari ng rem ov er head, 10 mm
Rem oyer shaft, 10 mm
Rem over weight
U.S.A. o n ly tools:
Beari ng rem over, 10 mm
Remover hand le
Rem over weig ht
07936·GE00200
07936·GE00100
07741·0010201
07936·GEOAOOO
07936-3710100
07936-371020 A or
07936-3710200
Drive new Torque limiter bearings in with the marks .. . . . , - -...
facing up.
TOOLS:
Driver
Attachment , 24 x 26 mm
Pilot, 10 mm
01749·0010000
07746·0010700
07746·0040100
ALTERNATOR COVER INSTALLATION
NOTE
• Route the wires and cables properly (page 1-21 ).
Blow through the oil passage in the alternator cover
with compressed air.
Clean the cover mating surfaces.
Apply molybdenum oil solution to the gear teeth
and splines.
Install the reduction gear shaft into the crankcase
and the reduction gear onto the gear shaft.
Inst all the torque limiter.
Install the two dowel pins and a new gasket.
[Ec>WEL PINS