Honda MUV700 big red Service Manual page 446

BRAKE SYSTEM
Coat a new piston seal with clean brake fluid and
install it into the seal groove in the cal iper cylinder.
Pack the inside of a new piston boot with 2 - 3 9 of
si licone grease and apply 0.8 9 of silicone g rease to
the seal areas (boot ribs).
Install the inside boot rib of piston boot into the
boot groove in the caliper cylinder properly.
Coat the caliper piston with clean brake fluid and
place it into the caliper body with the groove side
toward the brake pad. Cover the piston with the
boot carefully, then push the piston and set the out-
side boot rib into the boot groove in the piston to
seat the piston.
Instatllhe pad retainers onto the bracket.
Install new pin boots into the grooves in the bracket.
Apply 0.4 9 of silicone grease to the sliding area of
each slide pin.
Do not interchange
Install slide pin A (flat surfaces) and pin B (round
rhe pm A and
8 surface) into the caliper bracket to be sure each boot
rib is seated to the boot groove in the pin.
18-18
Install the brake pads onto the caliper bracket so the
wear indicator on the inner pad is facing the upper
side.
Install the bracket onto the caliper body with the
slide pin bolts.
-=:C.
PIN B
~
(l ower side)
BRACKET
!III>-"
I
--
PISTON SEAL
PIN A
...-'iSiII
(Upper side)
TS