Honda MUV700 big red Service Manual page 252

CYLINDER HEADIVALVE/CAMSHAFT
Install the rocker arms, wave washers (setting bolt
side) and arm shafts.
Align the bolt holes in the head cover and rocker
arm shaft by turning the shaft.
Install the setting boils with new sealing washers
and tighten the bolts securely.
INSTALLATION
WAVE WASHERS
ROCKER ARMS
!It!-'
....
SEALING WASHER ROCKER ARM SHAFT
Turn the crankshaft using the recoil stater knob and , - - - - - - - - -- - - - - - ----,
9-22
align the
uT"
mark with the index notch, then check
the cam lobes through the cam follower holes.
If the cam lobes face up, rotate the crankshaft one
full turn and match up the
"T~
mark again so the
cam lobes face down.
Coat the cam followers with engine oil and install
them into the cylinder head.
INDEX MARK