Honda MUV700 big red Service Manual page 442

BRAKE SYSTEM
Insert the bolts
from the pedal side.
8e
careful no!
10
cross-thread the
IOlnt
nuts.
18-14
Install new oi l seals onto the reservoir.
Install the reservoir into the master cylinder and
secure it with the bolt.
TORQUE: 2. 5 N'm (0.25 kgf·m, 1.8 Ibf.ft)
Install the master cylinder with the mounting bolts
and the nut, aligning the push rod slit with the brake
pedal.
Connect the brake pipes to the master cylinder with
the joint nuts.
Tighten the mounting nut s, then tighten the joint
nuts.
TORQUE:
M o unting nut: 27 N'm 12.8 kgf·m , 20 Ibf.ft)
Joint nut: 14 N ·m (1 .4 kgf·m , 10 Ibf·ft)
Connect the push rod to the pedal with the joint pin
and secure it with a new cotter pin.
Check the brake pedal height (page 4-21).
Fill and bleed the hydraulic system (page 18-7).
RESERVOIR