Rear Crankcase Cover Removal - Honda MUV700 big red Service Manual

SUB-TRANSMISSION / GEARSHIFT LINKAGE
REAR CRANKCASE COVER
REMOVAL
Remove the following:
- exhaust system (page 3-25)
- starter motor (page 23-6)
- rear propeller shaft (page 8-6)
Disconnect the front propeller shaft (page B-7
),
Remove the alternator cover and reduction gears
(page 11-5),
Disconnect the gear position switch 3P (black) con-
nector.
Remove the following :
- EOT sensor and sealing washer
- oil filler hose (from the pipe)
- two bolts, oil filler pipe and D-ring
Release the gear position switch wire from the wire
clamp on the crankcase cover.
Tempora rily install the gear selector arm and make
sure the sub-transmission is into neutral (page 12-
17 ).
8e careful nor to
Remove the following:
damage !he switch -
two bolts and gear position switch
pin on the poSItIOn -
O-ring
SWitch. -
bolt and ground cable
3P CONNECTOR
12-5