Honda MUV700 big red Service Manual page 514

REAR DRIVING MECHANISM
The shafl o.D. of
fhe left mboard JOint
IS
larger than the
fight
mboard Jomt
Do nor Interchange
them
20-10
Pack the each outboard joint with 35 - 55 9 of the
specified grease.
SPECIFIED GREASE: NKG708 (Kyodo Yu shiJ
Install the following :
- outboard boot
- new shaft boot bands
- inboard boot
Do not tighten the bands at this time.
Install the bearing with the small 0 .0 . facing the
drive shaft.
Install the snap ring with the chamfered side facing
the bearing.
Pack the specified grease to the each inboard joint
shown below.
SPECIFIED GREASE: NKG108 (Kyodo Yu shi)
Right inboard joint: 60 - 80 9
Left Inboard joint: 80 - 100 9
Install the inboard joint over the bearing .
Install the stopper ring into the groove in the
inboard joint properly.
Install the boot over the inboard joint securely.
Adjust the length of the drive shaft to be set the fig-
ure given below.
DRIVE SHAFT lENGTH:
Right: 578 mm (22.8 In)
l eft:
499 mm (19.6 in)
OUTB')AFm BOOT
NKG708
(35 - 559)
SHAFT BOOT BANOS
INB'OAFID BOOT
RING