Honda MUV700 big red Service Manual page 277

INSTALLATION
lubricate the needle bearing with molybdenum oil
solution. Install the washer and bearing onto the
crankshaft.
Install the woodruff key into the key groov e.
Clean any oil from the tapered port ion of the crank-
shaft and flywheel thoroughly.
Install the flywheel/staner driven gear by aligning
the key -way with the key on the crankshaft.
Apply engine oil to the flywheel boll threads and
seating surface, then install the washer and bolt.
Hold the flywheel using the special tool and tighten
the bolt.
TOOL:
Flywheel holder
01725·0040001 or
equivalent commer-
cially available in
U.S.A .
TORQUE: 108 N 'm (11,0 kgf-m , 80 Ibf.ft)
Install the feaf crankcase cover (page 12-7).
AL TERNATORISTARTER CLUTCH
11-13