Pinion Ball Bearing And Shim Replacement - Honda MUV700 big red Service Manual

Covertheclulch
Install the special toots onto the pinion gear shaft
housing matmg
and gear case. Using a heal gun, heat the case.
surface with
aluminum shims or
TOOLS:
an equIValent to
Pinion puller base
prevent damagmg
Puller shaft and nut
07HMC-MMB0110
07965-VM00200
070MF-HP50100
It
Threaded adaptor
U .S.A. TOOLS:
Take care not to
contact the support
blocks agamst the
gear teeth.
Pinion puller base
Puller shaft
Special nut
Threaded adapt o r
07HMC·MM8011A
0193'·ME4010B
01931·HB3020A
070MF·HP5Al00
Pull the pinion assembly out from the gear case .
PINION BALL BEARING AND SHIM
REPLACEMENT
Press the pinion gear out of the bearing.
Remove the pinion shim.
Replace the pinion jOint needle bearing in the shaft
end if necessary (pa ge 19-34).
Install the shim and bearing onto the pinion gear.
NOTE:
• When the gear set, differential bearing, differen-
tial and/or gear case has been replaced, use a
2.00 mm (0.079 in) thick shim for initial reference.
Press the pinion gear into a new bearing until it is
fully seated by supporting the bearing inner race.
TOOL:
Attachment, 30 mm 1.0 .
01746·0030300
FRONT DRIVING MECHANISM
PULLER _ _
+
BASE
PULLER
- -SHAFT
ADAPTOR
PINION GEAR
19-33