Honda MUV700 big red Service Manual page 375

Install the breaker arm assembly over the center
shaft and adjust the upper r im supports t o fit the
outside rim diameter.
Install the top hold down nut and tighten it finger
tight.
Failure
10
back out
Pull the leverage bar down so the breaker shoe is
Ihebreakershoe
just below the rim lip. Turn the crank to fully push
two rums wl/lcause
the breaker shoe between the ti re bead and rim .
rhe shoe
to
scratch Once the shoe contacts the rim, back the crank out
the bead lock,
two turns to allow the shoe t o clear the rim 's bead
which may cause
lock.
rhe /;re
/0
leak.
Push down on the leverage bar to push the tire bead
over the bead lock. Use only short strokes on the
handle. While the shoe is still engaged, turn the
wheel as far as it will go between strokes as you
break the bead around the rim.
Remove the breaker arm assembly and flip the
wheel over. Install the breaker arm assembly, adjust
the shoe properly and break the other bead by fol-
lowing the above procedures.
Remove the tire from the rim using a tire changing
machine or ti re irons and rim protectors.
FRONT WHEEL/SUSPENSION
BREAKER ARM ASSV.
NUT
UPPER RIM SUPPORTS
LEVERAGE BAR
!
15-7