Honda MUV700 big red Service Manual page 480

FRONT DRIVING MECHANISM
19-22
Turn the arm shaft and set the clutch spring ends
onto
the housing groove
and the reverse side of the
stopper plate as shown.
Check the arm shaft for smooth operation.
Install the clutch sleeve with the large 0.0. side fac-
ing the inside.
Coat a new O-r ing with grease and install it into the
case groove.
Install the two dowel pins.
Aligning the fork claws with the sleeve groove,
install the final clutch housing while turning the
clutch arm, then secure it with the bolts.
Tighten the three bolts.
TORQUE: 25 N·m (2.5 kgf·m, 18 Ibf.ft)
Install the 4WD select switch with a
washer and tighten it.
TORQUE: 12 N'm (1.2 kgf-m , 9 Ibf.ft)
new sealing
Check the final clutch operation (page 19-141,
CLUTCH SPRING
lit
O-RII'G
Dm_ELPINS
......
FORK