Honda MUV700 big red Service Manual page 499

Make sure that the
dnve mode selector
leveris2WD
position and the
differential lock arm
IS 1rx.J< free (upperl
position.
Install the holder bracket and cover base with the
two bolts, and tighten them .
TORQUE: 10 N'm
11.0
kgf·m . 7 Ibf.ft J
FRONT DRIVING MECHANISM
Set the drive mode se lector lever to the 2WD posi· , - -- - - - - - - , -- - -- - - - - - -- ,
tion.
Install the spring onto the selector cable.
Insert the cable into the cable holder and connect it
to the clutch arm with the joint pin and adjusting
nut.
Set the groove in the cable grommet onto the cover
base end properly.
Install the retaining plate ont o the cable with the
concave facing the cable holder to secure the cable.
Operate the differential lock arm to the upper side to
set it to the lock free position .
Connect the differential lock cable to the lock arm
and install it into the cable holder by aligning the
flat surfaces.
Install the washer and a new cotter pin.
Screw the cable nuts t ogether gradually {to move
both nuts to the cable holder side) by your hands so
that the cable does not forced until they are touched
to the cable holder.
Tighten the cable nut while holding the other nut.
TORQUE: 26 N·m (2.7 kgf·m , 20 Ibf·ft)
Connect the breather hose and the different ial lock
switch connector.
RETAINING
PLATE
"J"!jL~,gr\
t i1'-'i'--
~
PIN
19-41