Honda MUV700 big red Service Manual page 248

CYLINDER HEADIVALVE/CAMSHAFT
Before Ins/allmg the
camshaft,
be
sure
the cylmder boll
(under the cam
shaff! is tightened
securelv (page 10-
9)
Make sure the
liming mark on the
sprocket aligns with
the cylinder surface
when the
r
marlc
is aligned with the
index notch.
9-18
Lubricate the camshaft bearings and cam chain with
engine oil.
Install the camshaft holder plate onto the camshaft
holders, aligning the holes with the dowel pins.
Place the camshaft assembly onto the cylinder and
I~""'~
install the cam chain over the sprocket while
align~
ing the timing marks (index l ines) on the sprocket
with the cylinder top surface and holder plate edge.
Locate the dowel pins into the holes in the cylinder
securely.
Be sure the timing marks lines up with the cyl inder •
,we"'"'
top surface and holder plate edge.
Install the four holder bolts and tighten them.
Apply molybdenum oil solution to the cam lobes.
Remove the stopper tool, and install the sealing bolt
with a new sealing washer and tighten it.
Install the cylinder head !page 9-20).