Brake Pedal Removal; Brake Pedal Installation; Brake Pedal Disassembly - Honda MUV700 big red Service Manual

BRAKE PEDAL
REMOVAL
Do
not force tile
mastsr cylinder
after removing the
brake pedal
assembly or the
brake pipeS will be
deformed
Release the retaining straps and open the front
hood.
Unhook the return and switch springs from the
brake pedal.
Remove the cotter pin and joint pin to disconnect
the push rod .
Remove the two nuts and four bolts, and the brake
pedal assembly _
INSTALLATION
Install the brake pedal assembly with the four bolts
and two nuts, aligning the pedal arm with the push
rod slit. Tighten the fasteners alternately.
TORQU E: 27 N' m !2.8 kgf·m, 20 Ibf.ft)
Connect the push rod t o the pedal with the joint pin
and secure it with a new cotter pin.
Hook the return spring and switch spring.
Close the front hood and secure it with the straps.
Check the brake pedal height (page 4· 21).
RETURN SPRING
SWITCH SPRIN G
COTTER PIN
NUTS
PUSH ROD
\
DISASSEMBLY
Remove the fo llowing:
- cotter pi n and washer
- pivot shaft
- brake pedal
- dust seals
BRAKE PEDAL
BRAKE SYSTEM
BOLTS
(8 x 35 mm)
BOLTS
(8x20mm)
SHAFT
18-27