Service Rules; Abbreviation - Honda MUV700 big red Service Manual

GENERAL INFORMATION
SERVICE RULES
1. Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that do not meet Honda 's
design specifications may cause damage to the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with
Engl ish fasteners.
4. Install new gaskets, O-rings, cotter pins, and lock plates when reassembling .
5. When l ightening bolts or nut s, begin with the larger diameter or inner bolt first. Then tighten to the specified torque
diagonally in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as show in the Cable and Harness Routing (page 1·21 ).
ABBREVIATION
Throughout this manual, the following abbreviations are used to identify the respective parts or systems.
Abbrev. t elTTl Full t elTTl
Af[
Automatic Transmission
CKP sensor
Crankshaft Position sensor
Clutch PC solenoid
Clutch Pressure Control solenoid
I
DLC Data Link Connector
-
DTC Diagnostic Trouble Code
ECT sensor Engine Coolant Temperature sensor
EEPROM
,
Electrically Erasable Programmable Read Only Memory_
ELR Emergency Locking Retractor
EOT sensor Engine Oil Temperature sensor
HDS
Honda Diagnostic System
. IACV
Idle Air Control Valve
~;sensor
Intake Air Temperature sensor
MAP sensor
Manifold Absolute Pressure sensor
_~IL Malfunction Indicator Lamp
DPS
Occupant Protective Structure
PCM Powertrain Control Module
(ECMfTCM ) (Engine Control ModulefTransmission Control Module)
PGM-Fl Programmed Fuel Injection
SCS connector
Service Check Short connector
TP sensor
Throttle Position sensor
VS sensor
Vehicle Speed sensor
2WD,4WD 2 Wheel Drive, 4 Wheel Drive
1-2