Torque Converter Inspection - Honda MUV700 big red Service Manual

Remove the following:
- stator shaft (while turning it counterclockwise)
- needle bearings
- washers
- thrust needle bearing
- inner colla r
- needle bearing
INSPECTION
NOTE .
• Replace the torque converter as an assembly
(from converter to inner collar).
Check the primary drive gear teeth for abnormal
wear or damage.
Hold the torque converter and turn the drive gear to
check the one-way clutch in the torque converter.
The gear should turn counterclockwise smoothly
and should not turn clockwise.
Check the needle bearings for abnormal wear or
damage.
Check the sprag clutch in the stator shaft for abnor-
mal wear, damage or irregular movement.
Check the sprag clutch contacting surface of the
inner collar for abnormal wear or damage.
DRIVETRAIN SYSTEM
SPRAG CLUTCH
STATOR SHAFT
INNER COLLA.R
14-43