Honda MUV700 big red Service Manual page 515

No te the installation
direcrton of Ihe
band (page 20-9)
Install the shaft boot band and a new outboard boot
band onto the outboard boot.
Bend down each band end and secure it with the
lock tabs. Tap the lock tabs with a plastic hammer.
Install the shaft boot band and a new inboard boot
band ont o the inboard boot.
Bend down each band end and secure it with the
lock tabs. Tap the lock tabs with a plastic hammer.
INSTALLATION
Install a new stopper ring into the groove in the
inboard joint splines.
The fight dflve shaft
Install the drive shaft by holding the inboard joint
is longer than the
until the stopper ring seats in the groove of the
left drive shaft.
Do differential.
nor
mterchange
them.
Be careful nOllO
damage rhe oil seal
in rhe gear case
Make sure the stopper ring is seated properly by
pulling on the inboard joint lightly.
Install the knuckle (page 17-8).
REAR DRIVING MECHANISM
OUTBC)AFID BOOT BAND
tI
INBOARD BOOT BAND
S"
INBOARD JOINT
20-11