1St Shift Clutch Installation - Honda MUV700 big red Service Manual

DRIVETRAIN SYSTEM
The
MI
gear
bearing has one
roJler mlssmg (rom
each cage
by
design
Apply engine oil to the gear teeth and needle bear-
ing, and install the following:
- thrust washer
- needle bearing
- Ml
gear
Install the mainshaft assembly (page 13-10).
1st SHIFT CLUTCH INSTALLATION
Blow through the oil holes in the primary driven
gear boss with compressed air.
Coat new O· rings with engine oil and install them
into the grooves in the driven gear boss.
Install the driven gear into the 1st shift clutch until it
is fully seated.
Apply engine oil to the gear teeth and install the Ml
gear guide and washer onto the mainshaft.
Coat new O-rings with engine oil and install them
into the mainshaft grooves.
Line up the tabs of the three clutch discs in the shift
clutch.
Align the d,scrabs
Carefully install the 1st shift clutch assembly onto
w,rh lhe gear gUIde
the mainshaft and onto the Ml gear guide until it is
leerh
fully seated (the whole of the shaft threads are
exposed).
14-56
--"' 1
M 1 GEAR
THRUST WASH"R
NEEDLE BE"RI.'G