Honda MUV700 big red Service Manual page 468

FRONT DRIVING MECHANISM
Pack the outboard joint with 35 - 55 9 of the sped-
fied grease.
SPECIFIED GREASE: NKG708 (Kvodo Vushi)
Install the following:
- outboard boot
- new shaft boot bands
- inboard boot
Do not lighten the bands at this time.
Install the bearing with the small
D.D.
facing the
drive shaft.
Install the snap ring with the chamfered side facing
the bearing .
The shaft 0.0 of Pack the inboard joint with 60 - 809 of the specified
the lefllnboard
JOint
grease.
IS
larger than lhe
fight inboard Jomt.
Do not mterchange
them .
19-10
SPECIFIED GREASE: NKG708 (Kyodo Yushi)
Inslall the inboard joint over the bearing.
Install the stopper ring into the groove in the
inboard joint properly.
Install the boot over the inboard joint securely.
Adjust the length of the drive shaft to the figu re
given below.
DRIVE SHAFT LENGTH:
Left: 582 mm (22.9 in)
Right: 486 mm (19.1 in)
NKG708
(60 -80