Release Lever - Honda MUV700 big red Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
RELEASE LEVER
Unlock the cargo bed by pulling up on the release
lever and then raise the bed.
Remove the six bolts and heat guard plate.
Release each return spring end off of the setting
hole in the bed frame.
Remove the following :
- four bracket bolts (from the bottom of the outer
brackets)
- four bracket nuts and bolts (from side face of the
inner brackets; nuts-inside/bolts-outside)
- release lever assembly (from the cargo bed
frame)
Remove the fo llowing from the release lever:
- outer brackets (separate them)
- retu rn springs
- nuts, bolts and inner brackets (sepa rate them)
When ins/ailing the
Installation is in the reverse order o f removal.
return springs, set
them
In
the correa
direc/ion
as
shown
3-20
TORQUE:
6 X 25 mm bracket bolt: 14 N'm 11 .4 kgf·m, 10 Ibf·ft )
Heat guard plate bolt : 8 N' m (0.8 kgf·m . 5.9 Ibf·ft)
INNER
BRACKET
BOLTS
(6x 12 mm)
6 x 25 mm
PLATE
NUTS
HOLE
BRACKET