Honda MUV700 big red Service Manual page 522

REAR DRIVING MECHANISM
20-18
ASSEMBLY
DIFFERENTIAL LOCK
o
O,/~~ARM
SHAFT
Q\
OILSEAL ~
@ .
BEARING (6007)
STOPPER ARM
-«
,
Apply grease to the lips of a new oil seal and install
it
into the clutch housing until it is fully seated.
Apply grease to the lock arm shaft outer surface
(fork and housing contacting surface).
Install the arm shaft, being careful not to damage
the oil seal, then install the shift fork with the bolt
hole facing up.
Install the fork spring and stopper arm and set the
shaft end into the pivot hole in the housing so the
spring end rest onto the spring pin on t he stopper
arm as shown.
Apply locking agent to the threads of the stopper
arm bolt.
Align the bolt holes wi th the shaft arm facing down,
then install the arm bolt with the washer and tighten
it.
TORQUE: 20 N'm (2.0 kgf·m,
14
Ibf·ft)
Hook the fork side spring end onto the underside of
the spring pin on the stopper arm, using a screw·
driver.
SHIFT FORK
SPRING
ARM
SHAFT
FORK
OIL SEAL
fI~~
SPRING
WASHER AND BOLT
C1m:J
ST(lPPI'R ARM
iPRl l NG END