Honda MUV700 big red Service Manual page 452

BRAKE SYSTEM
Be cenain the snap
ring
IS
firmly sBared
In
the groove
18-24
Coat a new O-ring with silicone grease and install it
into the sleeve piston groove.
Apply 0.' 9 of silicone grease to a new cup and
install
it
onto the adjusting bolt.
Instal! the adjusting bolt into the sleeve piston.
Apply 0.15 9 of silicone grease to the ends of the
rod and install it into the sleeve piston.
Install the piston assembly into the caliper cylinder
by aligning the pins of the piston with the holes in
the caliper.
Install bearing, spacer, adjusting spring and spring
guide onto the adjusting bolt.
Install the snap ring into the groove in the caliper
body with the chamfered edge facing in.
TOOL:
Snap ring pliers
07914-SA50001
Coat a new piston seal with clean brake fluid and
install it into the seal groove in the caliper cylinder.
Pack the inside of a new piston boot with 0.5 - 0.7 9
of silicone grease and apply 0.2 g of silicone grease
to the seal areas (boot ribs).
Install the inside boot rib of piston boot into the
boot groove in the caliper cylinder properly.
Coat the caliper piston with clean brake fluid and
place it into the caliper body with the groove side
toward the brake pad. Cover the piston with the
boot carefully, then install the piston onto the
adjusting bolt by turning il clockwise to retract it,
using the special
1001
or equivalent.
Be sure to set the outside boot rib into the boot
groove in the piston.
TOOL:
l ock nut wrench
07716-0020100
g
.AiSiti
D-RING
111
.AiSiti
CUP \
~~ '\:
BEARING \
SPRING
\~ .
~
BOLT
GUIO: SPACER
PISTON