Front Crankcase - Honda MUV700 big red Service Manual

CRANKCASE/CRANKSHAFT/BALANCER
Apply engine oil to new bearings.
Drive the bearings in w ith the ma rks facing up.
The mainsflafr
TOOLS:
bearing
Is
installed
Mainshaft Bearing
WJtf1
the sealed
Driver
side facing down.
Attachment, 42 x 47 mm
Pilot, 20 mm
Countershaft Bearing
Driver
Attachment, 52 x 55 mm
Pilot, 28 mm
07749·0010000
07746·0010300
07746·0040500
07749·0010000
07746·0010400
07746·0041100
Balancer and Shift Drum Bearing
Driver 07749·0010000
Attachment, 37 x 40 mm 07746· 0010200
Pilot, 17 mm 07746· 0040400
Output Shaft Bearing
Driver
Attachm ent, 62 x 68 mm
Pilot, 28 mm
FRONT CRANKCASE
07749·0010000
07746·0010500
07746·0041100
Remove the balancer and countershaft bearings
with the special tools.
TOOLS:
Balancer Bearing:
Bearing remover, 17 mm
Remover handle
Remover weight
Countershaft Bearing :
Bearing remover, 20 mm
Remover handle
Remover w eight
07936·3710300
07936·3710100
0774'· 0010201 or
07936·371020A or
07936·3710200
(U.S.A . only)
07936·3710600
07936·3710100
07741· 0010201 or
07936·371020A or
07936·3710200
(U.S.A . only )
Remove the oil feed pipe oil seal.
Drive the mainshaft and crankshaft bearings out of
the front crankcase.
Apply engine oil to the l ips of a new feed pipe oil
seal. Install the oil seal with the flat side facing the
crankcase until it is fully seated.
BEARING REMOVER
MAINSHAFT BEARING
13-11