Honda MUV700 big red Service Manual page 531

Be sure
to
wear
heavy gloves 10
avoid burns when
handling the heated
gear case
Using
a
torch to
heat the gear case
may cause
warpage.
Drive new bea rings into the gear case and cover .
TOOLS:
Case cover:
Driver 07749·0010000
Anachment, 62 x 68 mm 07746·0010500
Pilot, 40 mm 07746·0040900
Gear case:
Drive r 07749·0010000
Attachme nt, 72 x 75 mm 07746·0010600
Apply g r ease to the lips of a new oil seal and install
it
so that it is flush with the cover.
TOOLS :
Driver
Oil seal driver attachment
07749·0010000
07JAD· PH80101
PINION NEEDLE BEARING
Rotate the stopper r ing untit its end appea rs in the
access hole.
Strike gently near the end of the ring with a punch
to bend the end upward.
Grasp the end of the ring with needle-nosed pliers
and pull the stopper ring out through t he access
hole.
Heat the gear case to about 80°C (176°F) and
remove the needle bea ring, using the special tools.
TOOLS:
Bearing remover, 17 mm
Remover handle
Remover weight
07936-3710300
07936-3710100
07741-0010201 or
07936-3710200 or
07936-371020A
(U.S.A . only )
Remove the bearing cage and bearings from the
inside of the pinion bearing to allow the special tool
to grip the bearing.
REAR DRIVING MECHANISM
20-27