Honda MUV700 big red Service Manual page 388

FRONT WHEEL/SUSPENSION
Install the wheel hub/knuckle assembly onto the
drive shaft and arms, and install the ball joint nuts.
Tighten each nut to the specified torque and further
tighten until its grooves align wi th the cotter pin
hole.
TORQUE: 49 N·m (5.0 kgf·m , 36 Ibf.ftJ
Install new cotter pins.
~~~D. em,..R
PINS
g
Adjust the suspension arm angle with a jack sup- , - - - - - - - - - - - - - - - - - - ,
15-20
porting the lower arm so that the distance between
the centers of the shock absorber mounting bolt
holes is 394 mm (15.5 in).
After adjusting the angle, tighten all the upper and
lower arm pivot fasteners to the specified torque.
TORQUE (Upper and lower) :
64 N'm (S.S kg'·m, 47 Ibf.ftl
Install the shock absorber (page 15-21).
Install the drive shaft guard with new bolts and
tighten them.
TORQUE: 11 N'm (1 .1 kgf·m. 8 Ibf.ft)
Install the hose clamps with new clamp bolts and
tighten them.
TORQUE: 12 N'm (1 .2 kgf·m. 9 Ibf.ftJ
Install the front wheel (page 15-6).
Support
.-.~
BOLTS
fI