Crossbar - Honda MUV700 big red Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
CROSSBAR
3-8
Remove the following :
- seat center cover (page
3-5)
- center frame cover (page 3-7)
Remove the adjusting nut and joint pin to discon-
nect the parking brake rod. Remove the rod spring.
Remove the following from the crossbar:
- two bolts and brake cable holder
- throttle cable clip
- ignition coil wire and throttle body wire (untie
the wire band and release the ignition coil wire
from the wire clip)
- accessory socket 2P (g reen) connector
Remove the four 10-mm nuts and bolts.
Remove the four 12-mm bolts and the crossbar.
Installation is in the reverse order of removal.
TORQUE :
12 mm bolt : 64 N-m (6.5 kgf·m , 47 IbUt)
10 mm nut: 49 N -m (5.0 kgf·m, 36 Ibf.tt)
After installation, adjust the parking brake lever
(page
4·21).
ADJUSTING
NUT
CUP
WIRES
BAND
12 mm BOLT
10mm NUT
AND BOLT